Linein mp31/3/2024 ![]() For me that was unplugging the black connector from the head unit and plugging it into the white connector from our input box, and plugging the matching black connector from the input box into the head unit. Simply unplug the matching cord from your head unit into the receiving end of the input box cord. Or if they're marked 'ring' and 'tip' then the ring is always the right. If your RCA cord doesn't say which one is left and right, the red end is always the right. What we need to do is plug our RCA-to-mini cord into one set of those inputs, and hook up the connectors into the head unit. The black auxiliary input box has 2 connectors, one toggle switch, and 2 sets on RCA inputs coming off it. As you can see there was one spot where I couldn't reach the clip so I used my Leatherman to unlatch it.Īlright, now that you've got the face of the dashboard off, and your head unit out it's time to plug your new toys in. To fully remove the face of the dashboard I had to move the steering wheel and the shifter down to their lowest positions so make sure you have the parking brake set first. ![]() If you can't reach the clip with your fingers a flat head screwdriver does the trick nicely. It's usually really easy to safely remove them since there's normally only one way to snap it back on. As you pull the dash off be careful to not just rip it off as most of the cords to the buttons are clipped on the back. This is the only point I needed the screwdriver for, since I couldn't reach one of the clips with my fingers, and I just used my Leatherman. In my Suburban it just required gripping it hard on one end and slowly pulling it off. I would recommend looking up how to do it in your particular car just to be sure, but there really isn't much you can hurt. This is usually very easy since most dashboards just snap right in. This cord will be what connects to your music player. The basic tools required are: regular crescent wrench Flat head screwdriver Drill and bits (I used a 1/4" and a 5/8" bit) You'll also need a stereo mini (1/8") jack-to-RCA cord about 3 to 6ft long (depending on whether the folks in the back seat want to play with the iPod/mp3 player while your listening). I found the auxiliary input I wanted at Peripheral Electronics then bought it off ebay. I have actually tried both, and while they both work OK the inconsistency and lower quality of the FM transmitter and the reliability and constant cleaning required of cassette player if you listen to your ipod more than a few times a month just don't cut it when you can have a high quality maintenance free direct line-in for a little bit more. Many of you will notice that I have a cassette player as well as a working radio in the car so an FM transmitter or cassette tape with a headphone jack might be the more logical answer. While I will be adding it on my '99 Chevy Suburban, it can very easily be done on almost all cars, SUVs, and trucks. This instructable will show you how to add an auxiliary input, like a headphone jack, to your car so you can listen to an iPod/mp3 player/GPS or anything that has a line-out through your cars stereo.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |